3.1 Printing Inspection
General rule: The amount of solder paste printed on the pad is allowed to have a certain deviation, but the area covered by the solder paste on each pad shall be greater than 75% of the pad area.
3.2 Dispensing Inspection
Ideal glue spot: No trace of patch glue contamination can be seen on the pad and lead out end face. The glue spot is located in the middle of each pad, and its size is about 1.5 times that of the dispensing nozzle. The amount of glue is based on the solder end of the component and the PCB after mounting The pads should not occupy dirt.
3.3 Pre Furnace Inspection
3.4 Post Furnace Inspection
A good solder joint shall be full and well wetted, and the solder shall be spread to the edge of the pad.
In SMT , the statistics of quality defects is very necessary. In the quality defect statistics of reflow welding, we introduce DPM statistical method, that is, the defect statistical method of parts per million. The calculation formula is as follows:
Defect rate [DPM] = total number of defects / total number of solder joints * 106
Total number of solder joints = number of tested circuit boards × Solder joint
Total number of defects = total number of defects detected on the circuit board
For example, if there are 1000 solder joints on a circuit board, the number of detected circuit boards is 500, and the total number of detected defects is 20, it can be calculated according to the above formula:
Defect rate [ppm] = 20 / (1000 * 50) * 106 = 40ppm
XPCB Limited is a premium PCB & PCBA manufacturer based in China.
We specialize in multilayer flexible circuits, rigid-flex PCB, HDI PCB, and Rogers PCB.
Quick-turn PCB prototyping is our specialty. Demanding project is our advantage.
© 2022 - XPCB Limited All Right Reserved