PCB Blog Manufacturer| Get PCB Blog Cost, Quote

2021-09-09

Difference Between Wave Soldering and Manual Soldering in PCBA Processing (Part 1)

In the electronics industry, there are wave soldering and manual soldering for software materials in PCBA processing. Then, what are the differences between these two soldering […]

2021-09-06

7 Ways to Quickly Judge the Quality of Circuit Board Design (Part 6)

6-Trace width and routing The size of the traces carrying large currents should be adjusted appropriately. Figure 2 below shows the IPC (Printed Circuit Research Institute) […]

2021-09-06

the First Inspection Mechanism for PCBA Processing Plants (Part 2)

After the first piece of inspection, whether it is qualified or not, it should be approved by a full-time inspector. The inspector shall put the required […]

2021-09-06

the First Inspection Mechanism for PCBA Processing Plants (Part 1)

The first inspection mechanism refers to an error-proofing mechanism to prevent mass accidents. The first or first few products processed by the production line before the […]